Products – My Most Valuable Advice

Make A Fake ID

Are you planning to make a fake novelty ID for some good laughs? If you do, then it will be ideal to finish reading the whole content of this article in an effort to create a convincing fake ID regardless if it is a state identification card, driver’s license or whatever.

Here are some of the steps that you must be mindful about when planning to make one.

Step number 1. Scan the ID into the printer or computer – make it a point that you scan both the back and front sides and note any holographic elements in your ID.
Getting Creative With Resources Advice

Step number 2. Open the scan using image editing software – this is basically where the magic happens and by that, I mean the editing of info in the ID.
Learning The Secrets About Identifications

Step number 3. Insert a new photo – whenever possible, try to get an image that’s roughly the same size and resolution as the one present on the valid ID. Zoom in or zoom out of the new photo so the head will remain of the same size like in the original photo. You can adjust the brightness and contrast to match the original photo. And as long as the new picture isn’t too dark or too bright, you’re doing just fine.

Step number 4. Change the text fields – try finding fonts that are close to the one that’s used on the current ID, to be safe use courier w/ slab serif especially on older IDs. And for it to be a close match, consider adjusting the font spacing and size.

While entering a full name, do it without abbreviations and the only instance when you need to use it is for things like III or Jr. It will be wise of you to put a realistic birth date as well. When you’re using old ID as your template, you don’t like to keep it that way as it may conflict the year the person was born to how it actually looks personally.

Step number 5. Print out the new ID – as you are printing your new ID, put it on a heavy cardstock and make sure that you print both the back and front. After that, cut out every side of your new ID and glue the two sides so they’ll form a card. Overlapping edges must be trimmed.

Step number 6. Add holograms – this is actually optional but if you would like to add an extra layer of authenticity to the fake ID, then be sure to add holograms.